Heli Nation Talon F7 FusionĀ 20x20 Flight Controller
The new flagship flight controller from Heli Nation is here! This brand new F7 flight controller sports dual gyro setup in 90 deg phase. Combining that with F7 processing power will have your drone dialed in to the max.
Specifications
- MCU: STM32F722RET6 216MHz
- 2x ICM20602 GYROS 90 deg phase
- Built in Betaflight OSD
- Up to 8S (36V) direct battery power
- Buzzer pads for external buzzer
- Built in voltage monitoring resistor
- 5V 2A BEC
- Dedicated LDO for Gyro, noise free gyro power
- Dedicated LDO for OSD, cleaner OSD signal
- Led strip shares 5V with 5V/2A BEC
- 6 UARTS: UART1, UART2, UART3, UART4, UART5, UART6
- Built in camera control pin with resistor and capacitor
- 5 Full UARTS with RX AND TX pins
- Logical pin layout for cleanest build possible
- 8 pin 4 IN 1 ESC plug
- Remapable LED pad for additional motor output
- TX3, RX3 can be used for I2C for external compass
- 5V, VBAT selectable VTX and CAM power
- 16M Blackbox flash chip
- No flicker VTX pit mode switch (positive switch)
- M4 Can be selected either led_strip signal or M4 signal for RPM filtering
- 20 X 20 mounting hole with true 25mm board dimensions
To get Motor 4 to work please use the CLI command below. A custom hex is coming soon.
resource MOTOR 6 None. Resource MOTOR 4 C08. Save.
